Neumann TLM 170 R mt Black Large Diaphragm Multi-Pattern Condenser Microphone

TLM 170 R mt Black Large Diaphragm Multi-Pattern Condenser Microphone description:

The Neumann TLM 170 R is a large diaphragm, multi-pattern condenser microphone intended for vocal, general instrument recording and broadcast applications. The microphone features a very smooth, flat frequency response resulting in transparent sound reproduction without any coloration to the signal on output.

Five directional characteristics are selectable by means of a rotary switch. In the sixth position, marked R, the directional patterns can be controlled remotely with the N 48 R-2 power supply. There is no special cable necessary for this purpose. The microphone has at its rear a 10 dB attenuation switch for extremely high sound pressure levels, and a high-pass filter to suppress structure born noise.

Uses the EA170 shockmount (not included).

Features:

• Local and remote controlled large diaphragm microphone
• Pressure-gradient transducer with double membrane capsule
• Five directional characteristics: omni, wide angle cardioid, cardioid, hypercardioid, figure-8
• Patented circuitry for remote and local switching of directional characteristics
• Switchable low frequency roll-off and 10 dB preattenuation
• Tiltable, elastically suspended bracket mount
• High SPL Capability - 154dB with prettenuation
• A wooden box and dust cover is included with the microphone

Specifications:

• Acoustical operating principle: Pressure gradient transducer
• Directional pattern: Omnidirectional, wide angle cardioid, cardioid, hypercardioid, figure-8
• Frequency range: 20 Hz - 20 kHz
• Sensitivity at 1 kHz into 1 kohm: 8 mV/Pa
• Rated impedance: 50 ohms
• Rated load impedance: 1000 ohms
• Equivalent SPL CCIR 468-3: 26 dB
• Equivalent SPL DIN/IEC 651: 14 dB-A
• S/N ratio CCIR 468-3: 68 dB
• S/N ratio DIN/IEC 651: 80 dB
• Maximum SPL for THD 0.5%: 144 dB
• Maximum SPL for THD 0.5% with preattenuation: 154 dB
• Maximum output voltage: 10 dBu
• Dynamic range of the microphone amplifier DIN/IEC 651: 130 dB
• Supply voltage: 48 V ± 4 V
• Current consumption: 3 mA
• Matching connector: XLR 3F
• Weight: 625 g
• Diameter: 60 mm
• Length: 152 mm