Audix ADX-20i Pre-Polarized Condenser Microphone

ADX-20i Pre-Polarized Condenser Microphone description:

The Audix ADX-20i is a pre-polarized condenser microphone designed to handle a wide variety of clip-on applications.

The Audix ADX20i is sonically superior as well as aesthetically pleasing and is ideally suited for saxophone, trombone, trumpet and other brass instruments.

With a smooth uniform response over a frequency range of 40 Hz – 20 kHz, the ADX-20i provides a rich, warm sound not typical of microphones this size. It is machined from solid brass and has a low reflective black e-coat finish. The ADX-20i operates on phantom power (9-52 volts) with the optional preamp module APS-910. It may be used in battery mode with optional phantom power adapter (APS-911 not included). The ADX-20i can be utilised with a wireless system. Depending on the brand of wireless and the connector configuration of the instrument body pack, the ADX-20i connector would need to be modified accordingly.

Low noise electronic circuitry, and balanced low impedance output allow for interference free performance even with long cable runs.

Audix ADX20i Features

• High tension spring clamp keeps mic in place
• Multi-position gooseneck
• Highly accurate sound reproduction
• For micing Saxophone, trumpet, trombone
• Clips on to hardware, stands, cabinets for “hard to mic” areas or instruments
• Also functions as a room ambience microphone for recording or broadcast

Audix ADX20i Specifications

• Transducer Type: Condenser (pre-polarized)
• Frequency Response: 40 Hz - 20 kHz
• Polar Pattern: Cardioid
• Output Impedance: 250 Ohms balanced
• Open Circuit Sensitivity: 5.2 mV
• Equivalent Noise Level: 29 dB (A weighted)
• Signal to Noise Ratio: 65 dB (ref 1k @ 1 Pascal)
• Power Requirements: 9 - 52v phantom
• Maximum SPL: 130 dB
• Cable/Connector: Shielded 6ft cable terminating to a miniature 3 pin XLR-f
• Phantom Adapter: mini XLR male - XLR male
• Polarity: Positive voltage on pin, 2 relative to pin 3 of output XLR connector
• Housing: Machined Brass
• Gooseneck: Flexible steel
• Weight: 1.7 oz/4.7 grams (without cable)