This exclusive bundle features the compact dual channel Class A Audient MiCO Preamp, and not one, but two beautifully engineered sE R1-Ribbon Microphones. Puts the smooth classic sound of a hand-crafted Ribbon mic within reach of any user – buy today and save.
Click Below for Audient MiCo News and Reviews
Audient MiCO Dual Mic Preamp
A compact, feature packed twin Mic Pre with built in ultra-high quality ADCs, making it an ideal front-end for desk-top users.
The front-end design is Audient's renowned balanced discrete Class A design which is also used in the ASP008 and the ASP8024 mixing console - guaranteeing outstanding sonic transparency and detail.
Audient Mico also features one channel of the unique HMX harmonic sculpting technology from the Audient Black Pre making the creation of vintage style character and complexity as simple as turning one knob. For recording a single source with twin mics or mic+DI, the Variphase control on Mico's second channel allows precise phase alignment (or creative mis-alignment) of the two signal paths.
sE R1-Ribbon Microphone
The sE RIBBON is a beautiful piece of engineering. Its single ‘Figure of 8’ polar pattern is derived from an incredibly fine 2 micron Aluminium membrane. As such it has a higher-than-normal frequency roll-off (at around 7KHz), and greater sensitivity, producing a more open and natural sound than you’d expect form a ribbon mic. The RIBBON is ideally suited to recording Electric Guitar cabs, Overhead Drum micing, Brass and woodwind Instruments, String Sections and for Commercial Broadcast and Voice Over. It comes with a 10 year replacement capsule guarantee.
The sE Ribbon brings the advantages of the smooth classic sound of a high quality hand crafted Ribbon microphone within the reach of more users.
Audient MiCO & sE R1-Ribbon Bundle
- Audient MiCO Features:
- Twin ASP008 discrete Class A Mic Pres
- Rear panel Mic/Line inputs on Combi XLR/Jack
- Rear panel line output on XLR
- Switchable Hi-Pass filters - 40Hz, 80Hz, 120Hz
- Phase invert
- Switchable 48V phantom
- -20dB Pad
- 18 to 66dB gain continuously variable
- Unique to Ch 1: Front panel DI input - 500kOhms, HMX Harmonic sculpting function from Black Pre
- Unique to Ch 2: Variphase - phase shift between 0-180o
- Ultra-high performance 24 bit 44.1/48/96kHz low-jitter internal clock
- 44.1 to 192kHz using external word clock
- AES/EBU, S/PDIF Coaxial and TOSLINK outputs
- Word Clock input on BNC
- Switchable Word Clock termination
- sE R1-Ribbon Features:
- 1.8 Micron pure aluminum ribbon element
- Large ribbon geometry design
- Rare Earth Neodymium Magnet
- VOX – Velocity Optimized Extension for superior sensitivity / output
- Warranty includes 3 Ribbon replacements
- Recommended for: Electric Guitar, Overhead Drum micing, Brass Instruments, Vocals, Horn Sections, Woodwind Instruments, String Sections, Broadcast
- Specifications:
- Operating Principle: Electrodynamic pressure gradient (velocity Microphone)
- Polar Pattern: Figure-8
- Transducer Element: 1.8-micron aluminum ribbon - 45mm/1.77" tall, 4.5mm/.177" wide
- Magnets: Rare Earth Neodymium
- Frequency Response: m30 -15,000 Hz +/- 3dB
- Output Sensitivity: > -52 dBv Re. 1v/pa
- Output Impedance: 300 Ohms
- Rated Load Impedance: 300 Ohms
- Maximum SPL: >135dB over rated frequency response (more over 1K…)
- Powering: Not needed or recommended. Tolerant of properly wired phantom power through a good cable.
- Output Connector: Male XLR 3 pin
- Dimensions: 168mm L, 40mm W
- Weight: 450g
- Finish: Mesh grille: satin nickel, Body: matte gray
SE Electronics Ribbon Mic Set and Audient Mico Dual Mic Pre (code 85265)
Limited offer includes Audient Mico Dual Class A Mic Pre and a pair of sE Large Ribbon Microhones [UXB]
£599.00 (inc vat)